Guides:
Taking the Wii apart and install any Wii Modchip with
Clip
All models
Taking the Wii apart and install any Wii Modchip
All models
D2E-A9 Installation on
D2C, D2C2, D2E please look here
Diagrams from www.d2sun.com
D2Sun v1.1 Installation diagrams (for Clipinstallation
you only need the switch settings on the bottom)
D2Sun v1.1 Installation with Clip on DMS, D2A, D2B
please look here
D2Sun v1.5 Installation with/without Clip on DMS, D2A, D2B,
D2C, D2C2, D2E please look here
D2Sun v1.3A5
(alternative K Point for D2E Epoxy)
D2CPro
Installation,
Easy
Board Information,
YouTube Video
(Disable the chip, just press and hold "reset" when
starting the console)
D2CKey Installation,
Alternative Installation,
Leds
New D2B cut
pin chipset solution
Installation of the Argon SPI 9 wire
click here!
Installation of the FreeWii Modchip
All models
Installation of the WiiKey Modchip
All models
(pdf)
Update:
Wiikey Update 1.9s disk
(for both Original and Clone Wiikey) PAL-Europe
Wiikey Update 1.9s disk (for
both Original and Clone Wiikey) NTSC-USA
Wiikey Update 1.9s disk (for
both Original and Clone Wiikey) NTSC-Japan
WiiKey Update 1.9 disk (for
both Original and Clone WiiKey)
WiiKey Update recovery disk
(only in case of emergency)
Setup:
Setup Disk v1.1 PAL Europa
(8 MB)
Setup Disk v1.1 NTSC America
(8 MB)
Setup Disk v1.1 NTSC Japan
(8 MB)
Setup Disk v1.2
(country must be set before burning) (10 MB)
Setup Disk v1.3 (all countries)
(19 MB)
Building an
SD-Card Adaptor
Check your Wii Chipset from outside with the
Nitendo-Scene Wii Serial Tracker (external link)
