|
Installation
of a Plug-Modchip into the Playstation 2
PS2
V5/V6 Chip "No Solder" Mod Chip Installation Instructions
Please make sure the Playstation
2 Model you are modifying is a model with a model no. SCPH-3000xR,
while the X can stand for different numbers (picture 1). If
the model is correct, please open the Expansion Bay to check
if your unit has the screws like in picture 2.
The
model numbers can be SCPH-30001 R, SCPH-35001 R, SCPH-30002
R, SCPH-30003 R, and so on.
Whatever the model number is, it must have
the R after the model number.
The model shown below is used for reference only.
|
Make
sure to double check that the screw shown
below is actually in your system.
Simply take out the expansion slot cover and
check to see if the screw shown below is in
your console, if it is, it is safe to purchase
this modchip as you have a V5/V6 console.
If you dont have the screw in the expansion
slot please CHECK
HERE if you have a V4 PS2 model which
is compatible with our V4 PnP Key. |
|
| (1)
Please prepare a screwdriver and a tweezers (for
the flat ribbon cable).
(2) Unplug
the power of your PS2 console.
Turn over the PS so you can see that 8 plastic covers
as shown in the picture.
|
(3) Remove the 8 covers
and unscrew the eight screws.
(4) If there is a
sticker on your consoles, remove it as shown below.
(5) Remove the upper
part of the PS2 case now.
(6) Remove the power
and eject buttons as shown in the following illustration:
(7) Remove the screws
as shown below to remove the lower casing of the PS2 console:
(8) At the left side,
near the CD tray, there are 3 flat ribbon cables, as shown
in the first of the two following pictures.
Unplug the left and the middle one of the three cables.
| (9)
Connect the two flat cables to the PS2 R-Mod Board
exactly as shown here: |
| |
(10) Now connect the
PS2 R-Mod to the two connectors where you previously removed
the two flat cables.
(11) Now Re-assemble
the PS2. There was No soldering required.
|
