modchip PS2
switch language

Playstation, PS2, XBOX & Wii Mod Chip
PLAY YOUR COPY!

 

Playstation 2:
Visit the shop
Installation

Playstation 1:
Visit the shop
How to install

XBOX:
Visit the shop
How to install

Wii:
Visit the shop
How to install

GameCube:
Visit the shop
How to install

Nintendo DS:
Visit the shop
Usage

INSTALLATION INSTRUCTIONS
Messiah

Make the wires as short as possible so you get no problems when you put the PS2 together again, also with too long wires you might get timing problems, even these problems should have been fixed with the latest update of the Messiah.

The programming connections at the bottom of the Messiah have the far left 4 pads not used, therefore these can be adapted for making a nice solder bridge mount to the PS2 Motherboard ensuring a solid mount, and also a nice ventilation distance above the modchip for cooling of the ASIC. You do not need to insulate the bottom of the Messiah as the circuit tracking is coated with an insulation.

We recommend to use for GND and +3.3 Volt a little bit stronger wire.


V3 CONSOLE 

Close these soldering bridges

The programming connections at the bottom of the Messiah have the far left 4 pads not used, therefore these can be adapted for making a nice solder bridge mount to the PS2 Motherboard ensuring a solid mount, and also a nice ventilation distance above the modchip for cooling of the ASIC. You do not need to insulate the bottom of the Messiah as the circuit tracking is coated with an insulation.

We recommend to strip the wire longer, cut most of the strands of the stranded wire, so you maybe keep 2 or 3. These 2 are small enough to make the soldering connections. Once all the connections are made, glue the wires so they can not make an contact between each other.

 

 

 

V4 CONSOLE

Close these soldering bridges.

We recommend to make the points: A, B, C, I and H like shown on this picture. For the points direct on the chip you better use the alternative points on the other side od the motherboard.

ALTERNATIVE CONNECTION POINTS


V5 and V6 CONSOLE

Close these soldering bridges

The programming connections at the bottom of the Messiah have the far left 4 pads not used, therefore these can be adapted for making a nice solder bridge mount to the PS2 Motherboard ensuring a solid mount, and also a nice ventilation distance above the modchip for cooling of the ASIC. You do not need to insulate the bottom of the Messiah as the circuit tracking is coated with an insulation.

ALTERNATIVE CONNECTION POINTS